CRJF750N80G2E CR Micro 800V 7A N-Channel MOSFET TO-220F

The CR Micro CRJF750N80G2E is a 800 V 7 A N-channel MOSFET in a TO-220F package, built on the Super Junction process. On-resistance is 650 mΩ typical and 750 mΩ maximum at a 10 V gate drive; threshold voltage spans 3 to 4 V.

Key Specifications

Same-Rating Selection Table

14 part numbers share the same 800 / TO-220F / N rating — sorted by rds(on) typ.

Process Technology

Super Junction — alternating p/n pillars in the drift region cancel part of the vertical field, so Rds(on) grows almost linearly with breakdown voltage instead of quadratically. Best Rds(on) per unit area in the 500–800 V band, at the cost of a harder body-diode reverse recovery and more sensitivity to dv/dt during commutation.

Applications

High-voltage offline supplies, active clamp topologies, and single-stage PFC.

Selection Notes

• Rds(on) rises with junction temperature. Size the heatsink against the hot value given in the datasheet, not the 25 °C number in the table above.
• If the gate is driven below 10 V, check the 4.5 V Rds(on) line — parts without that rating are not characterised for logic-level drive.
• For high-frequency stages compare Qg and Ciss against the Rds(on) gain. A part one bin lower in Rds(on) often costs more switching loss than it saves in conduction.
• The body diode recovery of low-Rds(on) parts can be severe in bridge topologies. Verify dv/dt and dead time against the datasheet before dropping it into a half bridge.

Common Questions

Is the CRJF750N80G2E an N-channel or P-channel device?

It is N-channel. The drain-source rating is 800 V.

Can the CRJF750N80G2E be driven at 4.5 V?

No 4.5 V on-resistance figure is published for this part. It is characterised at 10 V gate drive, so use a driver that reaches 10 V.

What is the gate threshold voltage of the CRJF750N80G2E?

VGS(th) is specified between 3 and 4 V. Below the lower figure the part is off; above the upper figure it is fully on at the rated current.

What package does the CRJF750N80G2E come in?

TO-220F. Check the datasheet mechanical drawing for lead spacing and thermal pad dimensions before laying out the footprint.

How do I choose between the 14 part numbers in this rating group?

All 14 share the same voltage and package class. Sort by on-resistance first, then check gate charge: the lowest Rds(on) part is not automatically the best choice if the stage switches at high frequency. The table above lists them in ascending Rds(on) order.