CRXXH45M220G2 CR Micro 2200V 55A SiC MOSFET TO-247Plus-4H

The CR Micro CRXXH45M220G2 is a 2200 V 55 A N-channel silicon carbide MOSFET in a TO-247Plus-4H package. 53 mΩ typical at a 15 V gate drive (70 mΩ maximum); 54 mΩ typical at 18 V; Qg is 163 nC; VGS(th) 2 to 4 V.

Key Specifications

Same-Rating Selection Table

2 part numbers share the same 2200 / TO-247Plus-4H / N rating — sorted by rds 15v typ.

Process Technology

Silicon carbide has a critical field roughly ten times that of silicon, so the drift layer can be far thinner for the same blocking voltage. The result is a much lower specific on-resistance at 1200 V and above, and a breakdown voltage that barely moves with temperature. The trade-offs are a narrower gate window and a body diode that should not carry continuous third-quadrant current.

Applications

Solar inverters, three-phase motor drives, UPS, and railway auxiliary converters.

Selection Notes

• Silicon carbide holds a much flatter Rds(on) over temperature than silicon, but the gate window is narrow. Drive at 15–18 V on and a negative or zero volt off bias as the datasheet specifies.
• The body diode is not intended for continuous third-quadrant conduction. Where the topology requires it, check the datasheet's reverse conduction figures or add an external Schottky.
• Switching speed is limited by the gate loop, not the die. Keep the gate loop inductance low and budget for a negative turn-off spike on the gate.
• Paralleling needs matched VGS(th). Because VGS(th) spread is narrow the parts parallel well, but layout symmetry still decides current sharing.

Common Questions

Is the CRXXH45M220G2 an N-channel or P-channel device?

It is N-channel. The drain-source rating is 2200 V.

Can the CRXXH45M220G2 be driven at 4.5 V?

No 4.5 V on-resistance figure is published for this part. It is characterised at 15 V gate drive, so use a driver that reaches 15 V.

How much gate charge does the CRXXH45M220G2 need?

Qg is 163 nC. Size the driver against that figure at your switching frequency, and add the gate loop loss to the total dissipation budget.

What package does the CRXXH45M220G2 come in?

TO-247Plus-4H. Check the datasheet mechanical drawing for lead spacing and thermal pad dimensions before laying out the footprint.

How do I choose between the 2 part numbers in this rating group?

All 2 share the same voltage and package class. Sort by on-resistance first, then check gate charge: the lowest Rds(on) part is not automatically the best choice if the stage switches at high frequency. The table above lists them in ascending Rds(on) order.