
| Parameter | Value |
|---|---|
| Orderable part number | CMLA0706-701-R |
| Common-mode impedance | 700 ohm typical, 500 ohm minimum |
| DCR maximum | 15 mOhm |
| Rated current | 4 A |
| Rated voltage | 125 Vdc |
| Withstanding voltage | 125 Vdc |
| Insulation resistance | 10 Mohm minimum |
| Package | 8.0 x 6.2 x 4.0 mm max |
| RoHS | Compliant (-R suffix) |
A common-mode choke puts the same current through both windings in the same direction, so the differential signal passes through untouched while the common-mode noise sees the full impedance. It is the cheapest way to bring a switching node inside the emissions limit.
For a DC-DC output filter this is the part that decides whether the noise stays inside the conducted limits, and how much margin the design keeps at the top of the load step.
CMLA 是车规共模噪声抑制芯片电感,700 Ohm 典型,电流 4–8 A。
Rated voltage 125 Vdc and 10 Mohm insulation resistance are what make this usable on an automotive bus: the part has to survive the transients and the isolation test without leaking current into the signal.
Can I put it on a power line?
Only if the rated current covers the line. CMS is a signal-level series - for amps of current look at CMLA or a larger package.
Can I put it on a power line?
Only if the rated current covers the line. CMS is a signal-level series - for amps of current look at CMLA or a larger package.
Does it affect my signal?
Only through DCR and the small amount of leakage inductance. The differential signal is not filtered by design.
Design note: pick the choke by impedance at the noise
frequency, then confirm DCR and rated current against the signal or the rail.

Dimensional drawing and recommended PCB pad layout from the Eaton data sheet. Tolerances and pad dimensions are as printed on the drawing; check the outline against your layout before release.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd