Eaton CMLA1211-701-R - 700 Ohm Common-Mode Inductor
Eaton CMLA1211-701-R - 700 Ohm Common-Mode Inductor

Eaton CMLA1211-701-R - 700 Ohm Common-Mode Inductor

Share
Eaton CMLA1211-701-R: 700 ohm common-mode inductor, 8 A rated, 125 Vdc, 13 x 11.5 x 4.8 mm max.
    • Product Details
    • Download

    Eaton CMLA1211-701-R - 700 Ohm Common-Mode Inductor

    CMLA1211-701-R: common-mode choke, 700 ohm, DCR 6 mOhm, 13 x 11.5 x 4.8 mm max.

    Electrical Specifications

    ParameterValue
    Orderable part numberCMLA1211-701-R
    Common-mode impedance700 ohm typical, 500 ohm minimum
    DCR maximum6 mOhm
    Rated current8 A
    Rated voltage125 Vdc
    Withstanding voltage125 Vdc
    Insulation resistance10 Mohm minimum
    Package13 x 11.5 x 4.8 mm max
    RoHSCompliant (-R suffix)

    Reading the Data Sheet

    A common-mode choke puts the same current through both windings in the same direction, so the differential signal passes through untouched while the common-mode noise sees the full impedance. It is the cheapest way to bring a switching node inside the emissions limit.

    Interwinding capacitance is the mechanism behind the high-frequency behaviour: above the capacitance the choke stops blocking and starts passing. Leakage inductance is the part of the inductance that escapes the core and does not help.

    Series Positioning

    CMLA 是车规共模噪声抑制芯片电感,700 Ohm 典型,电流 4–8 A。

    • Typical use: 汽车 12 V 电源线、动力总成供电线滤波.
    • 车规件除了阻抗还要看额定电流:同样的阻抗,电流越大体积越大,DCR 越低。
    • Data sheet 4315.

    The 700 ohm impedance is at the frequency where the noise lives. Below it the choke is close to transparent, and above it the interwinding capacitance takes over.

    Frequently Asked Questions

    Does it affect my signal?
    Only through DCR and the small amount of leakage inductance. The differential signal is not filtered by design.

    What impedance should I pick?
    The one that gives the attenuation you need at the noise frequency of your circuit, then check that the DCR is acceptable on the signal.

    What impedance should I pick?
    The one that gives the attenuation you need at the noise frequency of your circuit, then check that the DCR is acceptable on the signal.

    Design note: pick the choke by impedance at the noise
    frequency, then confirm DCR and rated current against the signal or the rail.

    Mechanical Dimensions

    eaton-cmla-automotive-common-mode-noise-suppressor-chip-inductor-data-sheet mechanical dimensions and recommended pad layout

    Dimensional drawing and recommended PCB pad layout from the Eaton data sheet. Tolerances and pad dimensions are as printed on the drawing; check the outline against your layout before release.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message

    Shenzhen Gaorunxin Technology Co., Ltd

    Related Products