
| Parameter | Value |
|---|---|
| Orderable part number | CTX110611-R |
| Lamp power | 6 W |
| Primary inductance Lp | 20 uH |
| Turns ratio Ns/Np | 125 |
| DCR primary maximum | 132 mOhm |
| DCR secondary maximum | 291 Ohm |
| Primary voltage maximum | 11 V |
| Secondary voltage maximum | 1340 V |
| Secondary current maximum | 0.011 A rms |
| Primary voltage, abnormal | 16 V |
| Secondary voltage, abnormal | 2000 V |
| Package | See dimension drawing in the data sheet |
| Mounting | Surface mount |
| Operating temperature | 0 C to +70 C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data 4303 |
Outline drawing, winding arrangement and recommended pad layout are on
page 2 of Eaton Technical Data 4303; the package line above gives the body size where
the data sheet states it.
A CCFL inverter transformer drives a cold cathode fluorescent tube: the primary sees a few tens of volts from the Royer or push-pull stage, the secondary produces the strike voltage, and the turns ratio sets both. The numbers on this page are the design inputs for that stage, not marketing figures.
A 125:1 ratio with 11 V across the primary puts 1375 V on the secondary at full drive, against a tube strike requirement of roughly 1000 to 1500 V.
The rated 0.011 A rms into 1340 V is about 14.7 VA of lamp power, which is why the secondary winding is the thermal limit rather than the core.
Within the CTX110611 family this is item 1 of 1 in the Eaton catalogue.
The CCFL range covers 2.5 W to 6 W lamps in two case sizes, with turns ratios from 50:1 to 100:1 and secondary voltages up to 2000 V under abnormal conditions.
What does the Pout rating mean?
It is the lamp power the part is designed for, which sets the core size and the wire gauge. Running a 2.5 W part at 6 W will overheat the winding even if the voltage rating is met.
What is the abnormal condition rating for?
It is the voltage the transformer withstands when the lamp does not strike or is removed. In that state the inverter runs open loop and the secondary voltage climbs until something breaks down, so the part has to survive it until the protection circuit trips.
Why is the secondary DCR so high?
The secondary has many turns of very fine wire to reach 1300 V or more. Resistance scales with turns and inversely with wire area, so a high-ratio secondary inevitably has tens or hundreds of ohms.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd