Eaton CTX17-18765-F Coupled Power Inductor, 2 nH
Eaton CTX17-18765-F Coupled Power Inductor, 2 nH

Eaton CTX17-18765-F Coupled Power Inductor, 2 nH

Share
Eaton CTX17-18765-F: Two-Phase Coupled Power Inductor, 2 nH, 55 A, DCR 100 mOhm.
    • Product Details
    • Download

    Eaton CTX17-18765-F Coupled Power Inductor, 2 nH

    CTX17-18765-F at a glance: coupled power inductor, OCL 2 nH, DCR 100 mOhm.

    Specification Table

    ParameterValue
    Orderable part numberCTX17-18765-F
    Open circuit inductance (OCL), 0 Adc2 nH
    Full load inductance (FLL), minimum50 nH
    Irms55 A
    Isat133 A
    Isat2200 A
    DCR typical @ 20 °C100 mOhm
    MountingSurface mount
    Operating temperature-40 °C to +125 °C
    RoHSCompliant (-R suffix)

    How to Read These Ratings

    This is a coupled inductor built for a specific multiphase controller family. The winding ratio and the coupling are matched to the controller, so the part is chosen by the reference design rather than by inductance alone.

    The data sheet gives OCL and FLL separately because the core is biased in use. Select on FLL for steady-state ripple, on OCL to identify the part, and on the isolation rating for anything that crosses a boundary.

    Coupling is only useful inside the controller it was designed for. Outside that loop the mutual inductance can add to the ripple instead of cancelling it.

    What This Family Is For

    CTX17-18765 is a two-phase coupled inductor in a 10 x 10 mm, 4.0 mm high body, built for Maxim multiphase controllers. Two windings, one core, ripple cancellation by design.

    • Typical applications: Two-phase VRMs, point-of-load converters, Maxim multiphase controllers.
    • The two-phase coupling only cancels ripple at the duty cycle the controller is designed for; outside that window it can make it worse.
    • Data sheet 4418.

    Sizing and Layout Notes

    At 2 nH this part is at the design point the controller expects of the family. The winding that produces that inductance is also what sets the 100 mOhm DCR - more turns, thinner wire, more resistance.

    Efficiency is set by where you sit on the loss curve, and the curve moves with switching frequency. A part that is excellent at 300 kHz can be mediocre at 1 MHz with the same current, because the core loss term takes over.

    Frequently Asked Questions

    What is the operating temperature?
    -40 °C to +125 °C, ambient plus self-temperature rise.

    What is the isolation between windings?
    See the data sheet for the family - it is a functional rating, not a safety barrier.

    Should I use OCL or FLL for the ripple calculation?
    FLL. OCL is measured at zero bias; under load the core is biased and the inductance drops to the full-load value.

    Design note: the loop compensation assumes this coupling. Do not substitute a part with a different ratio without the controller vendor's blessing.

    Mechanical Dimensions

    eaton-ctx17-18675-coupled-power-inductor-data-sheet mechanical dimensions and recommended pad layout

    Dimensional drawing and recommended PCB pad layout from the Eaton data sheet. Tolerances and pad dimensions are as printed on the drawing; check the outline against your layout before release.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message

    Shenzhen Gaorunxin Technology Co., Ltd

    Related Products