Eaton CTX17-18765-R High Current Coupled Inductor
Eaton CTX17-18765-R High Current Coupled Inductor

Eaton CTX17-18765-R High Current Coupled Inductor

Share
Eaton CTX17-18765-R: Two-Phase Coupled Power Inductor, 2 nH, 55 A, DCR 100 mOhm.
    • Product Details
    • Download

    Eaton CTX17-18765-R High Current Coupled Inductor

    CTX17-18765-R at a glance: coupled power inductor, OCL 2 nH, DCR 100 mOhm.

    Electrical Specifications

    ParameterValue
    Orderable part numberCTX17-18765-R
    Open circuit inductance (OCL), 0 Adc2 nH
    Full load inductance (FLL), minimum50 nH
    Irms55 A
    Isat133 A
    Isat2200 A
    DCR typical @ 20 °C100 mOhm
    MountingSurface mount
    Operating temperature-40 °C to +125 °C
    RoHSCompliant (-R suffix)

    What the Numbers Mean

    High-current multiphase rails need magnetics that fit under the socket and still carry the current. This part is a coupled inductor in a low-profile surface-mount body, with both the open-circuit and the full-load inductance specified.

    The data sheet gives OCL and FLL separately because the core is biased in use. Select on FLL for steady-state ripple, on OCL to identify the part, and on the isolation rating for anything that crosses a boundary.

    Coupling is only useful inside the controller it was designed for. Outside that loop the mutual inductance can add to the ripple instead of cancelling it.

    Series Positioning

    CTX17-18765 is a two-phase coupled inductor in a 10 x 10 mm, 4.0 mm high body, built for Maxim multiphase controllers. Two windings, one core, ripple cancellation by design.

    • Typical applications: Two-phase VRMs, point-of-load converters, Maxim multiphase controllers.
    • The two-phase coupling only cancels ripple at the duty cycle the controller is designed for; outside that window it can make it worse.
    • Data sheet 4418.

    Sizing It Into a Design

    At 2 nH this part is at the design point the controller expects of the family. The winding that produces that inductance is also what sets the 100 mOhm DCR - more turns, thinner wire, more resistance.

    The loss budget is the whole story with a power inductor: core loss grows with frequency and flux swing, copper loss grows with current, and the two meet at a different point for every inductance in the series.

    Frequently Asked Questions

    Should I use OCL or FLL for the ripple calculation?
    FLL. OCL is measured at zero bias; under load the core is biased and the inductance drops to the full-load value.

    Can I substitute a different coupled inductor?
    Only with the controller vendor's approval. The coupling and the ratio are part of the loop compensation.

    What is the operating temperature?
    -40 °C to +125 °C, ambient plus self-temperature rise.

    Design note: the loop compensation assumes this coupling. Do not substitute a part with a different ratio without the controller vendor's blessing.

    Mechanical Dimensions

    eaton-ctx17-18675-coupled-power-inductor-data-sheet mechanical dimensions and recommended pad layout

    Dimensional drawing and recommended PCB pad layout from the Eaton data sheet. Tolerances and pad dimensions are as printed on the drawing; check the outline against your layout before release.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message