
| Parameter | Value |
|---|---|
| Orderable part number | CTX210403-R |
| Lamp power | 4 W |
| Primary inductance Lp | 44 uH |
| Turns ratio Ns/Np | 50 |
| DCR primary maximum | 220 mOhm |
| DCR secondary maximum | 165 Ohm |
| Primary voltage maximum | 26 V |
| Secondary voltage maximum | 1340 V |
| Secondary current maximum | 0.007 A rms |
| Primary voltage, abnormal | 40 V |
| Secondary voltage, abnormal | 2000 V |
| Package | See dimension drawing in the data sheet |
| Mounting | Surface mount |
| Operating temperature | 0 C to +70 C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data 4303 |
Outline drawing, winding arrangement and recommended pad layout are on
page 2 of Eaton Technical Data 4303; the package line above gives the body size where
the data sheet states it.
This is a surface-mount CCFL transformer in a potted case: ferrite core, split bobbin, secondary sectioned to keep the voltage stress manageable. The abnormal condition columns give the voltage the part survives when the tube fails to strike.
A 50:1 ratio with 26 V across the primary puts 1300 V on the secondary at full drive, against a tube strike requirement of roughly 1000 to 1500 V.
The rated 0.007 A rms into 1340 V is about 9.38 VA of lamp power, which is why the secondary winding is the thermal limit rather than the core.
Within the CTX210403 family this is item 1 of 1 in the Eaton catalogue.
The CCFL range covers 2.5 W to 6 W lamps in two case sizes, with turns ratios from 50:1 to 100:1 and secondary voltages up to 2000 V under abnormal conditions.
What does the Pout rating mean?
It is the lamp power the part is designed for, which sets the core size and the wire gauge. Running a 2.5 W part at 6 W will overheat the winding even if the voltage rating is met.
Why is the secondary DCR so high?
The secondary has many turns of very fine wire to reach 1300 V or more. Resistance scales with turns and inversely with wire area, so a high-ratio secondary inevitably has tens or hundreds of ohms.
What does the Pout rating mean?
It is the lamp power the part is designed for, which sets the core size and the wire gauge. Running a 2.5 W part at 6 W will overheat the winding even if the voltage rating is met.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd