
| Parameter | Value |
|---|---|
| Orderable part number | ECMT1V1714H-470-R |
| OCL minimum, (1-2) & (4-3) | 47 mH |
| DCR maximum @ +25 °C, (1-2) & (4-3) | 2 Ohm |
| Irms per winding, (1-4) short | 0.5 A |
| SRF minimum | 192 kHz |
| Hi-pot, coil-to-core | 1500 Vac, 2 s, 5 mA |
| Hi-pot, coil-to-coil | 1000 Vac, 2 s, 5 mA |
| Insulation resistance minimum | 100 MOhm |
| Rated voltage | 250 Vac |
| Package | through-hole, closed magnetic path, rated 250 Vac |
| Mounting | Through-hole |
| Operating temperature | -40 °C to +125 °C |
| Qualification | Commercial grade |
| RoHS | Compliant (-R suffix) |

Drawings from the Eaton data sheet: mechanical outline with rated mm dimensions, recommended PCB pad layout, and winding schematic. Tolerances and pad tolerances are stated on the drawing itself.
The construction is deliberately robust: separate winding sections, a closed magnetic path that reduces conducted emission, and coil-to-coil and coil-to-core isolation ratings specified separately. It is the choke you put on the input of industrial power equipment and then forget about.
The two winding sections are specified separately because a mismatch turns common-mode noise into differential noise. The Hi-pot figures are quoted coil-to-core and coil-to-coil - both are functional isolation ratings, and the 250 Vac rated voltage governs what lines the part may sit between.
Irms is rated per winding with the section short-circuited, which is the harshest thermal case for a common-mode inductor: the whole winding carries the current with no cancellation to help.
The typical and the maximum DCR are both quoted for a reason: production spread. A loss budget that has to hold across a build uses 2000 mOhm as the optimistic case and plans against the maximum.
ECMT is the through-hole common-mode family for industrial power equipment - motion controls, power supplies, solar and wind inverters, chargers - where high isolation and a robust soldered filter point matter more than board area.
Can I use it on a DC line?
The rated voltage is 250 Vac for the winding insulation; large unbalanced DC on the lines biases the core and reduces the impedance. Keep the lines balanced.
What is the SRF column for?
The self-resonant frequency is where the winding capacitance cancels the inductance; above it the choke stops being an inductor. Pick a part whose SRF sits above your noise band.
What is the SRF column for?
The self-resonant frequency is where the winding capacitance cancels the inductance; above it the choke stops being an inductor. Pick a part whose SRF sits above your noise band.
Design note: the SRF column is a minimum; the choke stops filtering above it. Match the part to the noise band, not just to the inductance.

Dimensional drawing and recommended PCB pad layout from the Eaton data sheet. Tolerances and pad dimensions are as printed on the drawing; check the outline against your layout before release.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd