
| Parameter | Value |
|---|---|
| Orderable part number | ECSTA1V1308-1070-R |
| Turns ratio secondary:primary | 70:1 |
| Secondary inductance minimum | 2700 uH |
| DCR secondary maximum | 1 Ohm |
| DCR primary reference | 3.9 mOhm |
| Hi-pot primary to secondary | 500 Vac |
| Sensed current maximum | 15 A |
| Package | 13 x 11 x 7.8 mm |
| Mounting | Surface mount |
| Operating temperature | -40 C to +125 C |
| Qualification | AEC-Q200 |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data ELX1192 |
Outline drawing, winding arrangement and recommended pad layout are on
page 2 of Eaton Technical Data ELX1192; the package line above gives the body size where
the data sheet states it.
The primary is a single turn – often just a trace or a busbar through the part – and the secondary is the wound coil. That is why the primary DCR is quoted in milliohm and the secondary DCR in ohm: the two sides are built completely differently.
With a 70:1 ratio, a 10 A primary current becomes 0.143 A in the secondary. Across a 50 ohm burden that is 7.14 V, which is what the controller actually sees.
The secondary winding of 2700 uH with 1000 mOhm of resistance sets both the low-frequency corner and the signal loss; both move if you change the burden resistor.
Within the ECSTA1V1308 family this is item 6 of 11 in the Eaton catalogue.
The ECST and ECSTA ranges cover 7 A to 15 A of primary current in EE4.4 to EE8.3 packages, with turns ratios from 20:1 to 200:1.
What turns ratio do I need?
Pick the ratio so the secondary current into the burden resistor gives the voltage the controller expects at the current you want to measure. Higher ratios give more resolution but more secondary inductance and DCR.
What turns ratio do I need?
Pick the ratio so the secondary current into the burden resistor gives the voltage the controller expects at the current you want to measure. Higher ratios give more resolution but more secondary inductance and DCR.
Why must the secondary be terminated?
The part is a current source. Left open, the secondary voltage rises until the core saturates or the insulation breaks down; the burden resistor is part of the circuit, not an optional extra.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd