Eaton EPM78V2-15R0-01R0R 15V 1A Step-Down Regulator
Eaton EPM78V2-15R0-01R0R 15V 1A Step-Down Regulator

Eaton EPM78V2-15R0-01R0R 15V 1A Step-Down Regulator

Share
EPM78V2-15R0-01R0R: Non-Isolated Step-Down Regulator, 18-32 V input, 15 V output, 1000 mA, 15 W.
    • Product Details
    • Download

    Eaton EPM78V2-15R0-01R0R 15V 1A Step-Down Regulator

    EPM78V2-15R0-01R0R at a glance: Non-Isolated Step-Down Regulator, 18-32 V input, 15 V output, 1000 mA, 15 W.

    Key Specifications

    ParameterValue
    Orderable part numberEPM78V2-15R0-01R0R
    Input voltage range18-32 Vdc
    Output voltage15 Vdc
    Output current at full load1000 mA
    Output power15 W
    Efficiency (max. / min. input)96.0/93.0 %
    Input current, no load25 mA
    Capacitive load, maximum330 uF
    PackageSIP
    Operating temperature-40 °C to +105 °C
    QualificationIndustrial
    RoHSCompliant
    Data sheetEaton Technical Data 11181

    Mechanical drawing, derating curve and application circuits are on the
    following pages of Eaton Technical Data 11181.

    Reading the Data Sheet

    This is a non-isolated step-down module with continuous short-circuit protection. It has no minimum-load requirement beyond one percent, which matters when the load can go to sleep.

    The input has to stay above 18 V for a 15 V output, which is about 3.0 V of headroom at the minimum. Below that the module drops out like the linear regulator it replaces.

    Where This Series Fits

    The EPM78 series covers six fixed outputs from 1.8 V to 15 V at 1 A, all pin-compatible with the LM78xx footprint.

    • A switching regulator in a linear socket still needs the input capacitor. Without it the ripple specification does not hold.

    Frequently Asked Questions

    Is the output isolated?
    No. Input and output share a ground; this is a replacement for a linear regulator, not an isolated module.

    Can it replace a 7805 directly?
    Electrically yes, but check the pinout: some 78xx clones swap the pin order. The Eaton part follows the standard SIP sequence, and the input capacitor is still required.

    What about the switching noise?
    It switches at 500 kHz, so the ripple is specified in millivolts peak-to-peak. For an analog load, add an LC filter after the module.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message

    Shenzhen Gaorunxin Technology Co., Ltd

    Related Products