
At 750 mA, GBA-3/4 is the rating most often picked when the measured load lands just under the next step up in the GBA range.
| Parameter | Value |
|---|---|
| Manufacturer / Series | Eaton / GBA Series |
| Orderable part number | GBA-3/4 (carton of 100) |
| Current rating | 0.75 A (1/2 A) |
| Voltage rating | 125 Vac |
| Interrupting rating | 10,000 A |
| Approval basis | UL Listed + CSA Certified |
| Indicating pin | red |
| Body | 1/4 x 1-1/4 in (6.3 x 32 mm) body with red indicating pin |
| Fuse type | non-time-delay (fast acting), pin indicating |
| Agency | UL Listed guide JDYX file E19180 (1/2-5 A); UL Recognized guide JDYX2 file E19180 (6 A, 10-15 A); CSA Certified class 1422-01 file 53787 (1/2-5 A); CE |
| Environmental | no RoHS or halogen-free claim is made on this datasheet |
In practice 750 mA covers desktop and appliance power inlets: single-phase equipment inlets and adapter outputs. Sizing closer than 20 % to the rating leaves no room for the ambient rise inside the enclosure.
GBA-3/4 (carton of 100); the packaging prefix, where the series uses one, goes in front of the part number rather than after it.Will GBA-3/4 carry 750 mA continuously without opening?
Yes. The published table shows no opening at 100 % of rating, so 750 mA is inside the continuous rating at 25 C. Ambient temperature inside the enclosure, not the nominal current, is what usually forces the next size up.
What fault current can GBA-3/4 clear?
10,000 A at rated voltage. That figure assumes a normal branch-circuit source impedance; a stiff transformer feeding the same circuit can exceed it, and then the fuse is no longer the protective device by design.
Can GBA-3/4 replace the next rating up in an existing design?
No. Dropping from a higher rating changes both the continuous headroom and the I2t, so a fuse that used to ride through inrush may now open on it. Match current, voltage, I2t and body before substituting.
Design note: resistance, I2t and voltage-drop values are typical unless identified as ratings. Verify the current data sheet and curves before release.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd