Eaton LAN2VSAS24351C2 Ethernet Isolation Transformer
Eaton LAN2VSAS24351C2 Ethernet Isolation Transformer

Eaton LAN2VSAS24351C2 Ethernet Isolation Transformer

Share
LAN2VSAS24351C2: LAN transformer, single port.
    • Product Details
    • Download

    Eaton LAN2VSAS24351C2 Ethernet Isolation Transformer

    LAN2VSAS24351C2 at a glance: LAN transformer, single port.

    Specification Table

    ParameterValue
    Orderable part numberLAN2VSAS24351C2
    PortsSingle
    Pins24
    Leakage inductance0.5 uH
    DCR maximum1.2 Ohm
    Inter-winding capacitance35 pF
    PackageSee dimension drawing in the data sheet
    MountingSurface mount
    Operating temperature-40 C to +85 C
    QualificationCommercial grade
    RoHSCompliant, -R suffix
    Data sheetEaton Technical Data ELX1375

    Outline drawing, winding arrangement and recommended pad layout are on
    page 2 of Eaton Technical Data ELX1375; the package line above gives the body size where
    the data sheet states it.

    How to Read These Ratings

    The magnetics in an Ethernet port do three jobs: isolate the PHY from the cable, block common mode noise, and match the line. This part is the transformer half, and the ports, pins and channel count are what decide whether it fits the connector pinout.

    Within the LAN2VSAS24351C2 family this is item 1 of 1 in the Eaton catalogue.

    What This Family Is For

    The LAN range covers 100BASE-T through 10GBASE-T, single to quad port, with and without PoE, in open-header SMT packages.

    • The magnetics set the return loss and crosstalk floor of the link. A marginal part cannot be fixed in layout.
    • Typical applications: rj45 network interface card; ethernet switch, router; selv/elv equipment; smart tv; data centers.
    • Design note: insertion loss and return loss are band specifications. Compare curves at the band edges, not the typical number.

    Frequently Asked Questions

    What does 1CT:1CT mean?
    Centre-tapped to centre-tapped, one to one. Ethernet PHYs are designed around this ratio, so a different ratio changes the impedance seen by the PHY and the link will not meet its return loss specification.

    Which port count do I need?
    One transformer per port. The single, dual and quad variants are the same magnetics repeated in one package, which is why the pin count scales with the port count.

    Does the part include the common mode choke?
    Only where the part number or the description says so. Many designs use a separate choke; the PoE variants with a CMC in the same package are marked as such.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message