
| Parameter | Value |
|---|---|
| Orderable part number | LD1-120-R |
| Inductance | 12.0 uH ±20% |
| DCR maximum @ +25 °C | 210 mOhm |
| Irms (DC, 40 °C rise) | 1.05 A |
| Isat | 1.18 A |
| Mounting | Through-hole |
| Operating temperature | -40 °C to +125 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data 4310 |

Drawing reproduced from Eaton Technical Data 4310: outline with rated mm dimensions, pad layout and marking. Tolerances are stated on the drawing.
A metalized drum core inductor is a wound coil on a drum-shaped ferrite core, with the winding metalized or the core coated so the part can be handled and soldered. It gives more inductance per volume than a multilayer part at the cost of a larger body and a more open magnetic path.
At 1.05 A the winding dissipates about 0.232 W in copper, using the 210 mOhm figure. That is the DC floor of the loss budget: ripple and core loss come on top of it.
Saturation is reached at 1.18 A. Beyond that point the inductance falls on the soft part of the curve, and the converter’s ripple grows faster than the load current does.
Within the LD1 family this is value 13 of 27, in a range that runs from 1 to 330 uH.
The drum core family covers about 1 µH to tens of microhenry in axial, radial and surface-mount bodies. It is the value range between the chip inductors and the large toroids.
Why use a drum core rather than a molded part?
More inductance per unit cost in the mid range, and a wider value selection. The trade is a more open magnetic path and a larger body.
Can it be used in a switching converter?
Yes, within its current and frequency range. Check the core loss at the switching frequency before assuming the DC rating is the limit.
Is the part shielded?
The drum concentrates flux in the core but the ends are open. Keep sensitive traces away from the axis of the part.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd