Eaton LD1-1R8-R 1.8 uH Metalized Inductor, Isat 3.05 A
Eaton LD1-1R8-R 1.8 uH Metalized Inductor, Isat 3.05 A

Eaton LD1-1R8-R 1.8 uH Metalized Inductor, Isat 3.05 A

Share
LD1-1R8-R: metalized drum core inductor, 1.8 uH, 2.35 A, Isat 3.05 A, DCR 42 mOhm.
    • Product Details
    • Download

    Eaton LD1-1R8-R 1.8 uH Metalized Inductor, Isat 3.05 A

    LD1-1R8-R at a glance: metalized drum core inductor, 1.8 uH, 2.35 A, Isat 3.05 A, DCR 42 mOhm.

    Specification Table

    ParameterValue
    Orderable part numberLD1-1R8-R
    Inductance1.8 uH ±20%
    DCR maximum @ +25 °C42 mOhm
    Irms (DC, 40 °C rise)2.35 A
    Isat3.05 A
    MountingThrough-hole
    Operating temperature-40 °C to +125 °C
    QualificationCommercial grade
    RoHSCompliant, -R suffix
    Data sheetEaton Technical Data 4310

    Mechanical Dimensions & Pad Layout

    LD1-1R8-R mechanical dimensions and pad layout

    Drawing reproduced from Eaton Technical Data 4310: outline with rated mm dimensions, pad layout and marking. Tolerances are stated on the drawing.

    The Figures Explained

    This is a wound inductor on a drum core with metalized terminations. The value range runs from about a microhenry into the tens of microhenry, which puts it in the region where a multilayer part would need too many turns to be practical.

    At 2.35 A the winding dissipates about 0.232 W in copper, using the 42 mOhm figure. That is the DC floor of the loss budget: ripple and core loss come on top of it.

    Saturation is reached at 3.05 A. Beyond that point the inductance falls on the soft part of the curve, and the converter’s ripple grows faster than the load current does.

    Within the LD1 family this is value 3 of 27, in a range that runs from 1 to 330 uH.

    Where This Series Fits

    The drum core family covers about 1 µH to tens of microhenry in axial, radial and surface-mount bodies. It is the value range between the chip inductors and the large toroids.

    • The open magnetic path means nearby metal changes the inductance. Keep the specified clearance to shields and screws.
    • Typical applications: buck or boost inductor; noise filtering and output filter chokes; computers; power supplies; test equipment instrumentation smd device.
    • Design note: the value tolerance is wide by design; do not build a resonant circuit around the nominal inductance without checking the band.

    Frequently Asked Questions

    Is the part shielded?
    The drum concentrates flux in the core but the ends are open. Keep sensitive traces away from the axis of the part.

    Why use a drum core rather than a molded part?
    More inductance per unit cost in the mid range, and a wider value selection. The trade is a more open magnetic path and a larger body.

    Why use a drum core rather than a molded part?
    More inductance per unit cost in the mid range, and a wider value selection. The trade is a more open magnetic path and a larger body.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message

    Shenzhen Gaorunxin Technology Co., Ltd

    Related Products