
| Parameter | Value |
|---|---|
| Orderable part number | MCL1608V1-100-R |
| Inductance | 10.0 uH |
| DCR maximum @ +25 °C | 1150 mOhm |
| Rated current maximum | 60 mA |
| SRF minimum | 17 MHz |
| Test frequency | 1 MHz |
| Test voltage | 50 mV |
| Package | 1.6 x 0.8 mm |
| Size code | 1608 (0603) |
| Mounting | Surface mount |
| Operating temperature | -40 °C to +85 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data 10926 |

Drawing reproduced from Eaton Technical Data 10926: outline with rated mm dimensions, pad layout and marking. Tolerances are stated on the drawing.
Where a circuit needs a small, stable inductance in a package measured in millimetres, the multilayer chip is the default. Its self-resonant frequency is the practical ceiling – above it the part behaves like a capacitor, so the SRF column is the first thing to check against the operating band.
The row reads 10.0 uH with a minimum Q of – at 1 MHz. Q is the ratio of reactance to resistance at that frequency, so a Q of – means the part’s loss is about 100 % of its reactance in that band.
Self-resonance is quoted as 17 MHz minimum. Below it the part is inductive; above it the inter-layer capacitance takes over. The margin between the operating band and 17 MHz is the design headroom.
Within the MCL1608V1 family this is value 29 of 30, in a range that runs from 0.047 to 12 nH.
The multilayer chip family covers nanohenry to a few microhenry values in 0402 through 1812 bodies. It is the range where the inductance is too small for a wound part to be practical and where the self-resonant frequency sets the usable band.
Can I replace a wire-wound chip with this part?
Only if the Q and the current rating suit the circuit. Multilayer parts have lower Q and lower current capability than wire-wound parts of the same size.
What happens above the self-resonant frequency?
The part becomes capacitive. Any filter or matching design has to keep the operating band below SRF, with margin for the tolerance of the value.
Can I replace a wire-wound chip with this part?
Only if the Q and the current rating suit the circuit. Multilayer parts have lower Q and lower current capability than wire-wound parts of the same size.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd