
| Parameter | Value |
|---|---|
| Orderable part number | MCL2V0603-R60-R |
| Inductance | 0.6 nH ±0.3nH |
| Q minimum | 14 |
| DCR maximum @ +25 °C | 60 mOhm |
| Rated current maximum | 600 mA |
| SRF minimum | 10000 MHz |
| Test frequency | 500 MHz |
| Test voltage | 50 mV |
| Package | 0.6 x 0.3 mm |
| Size code | 0603 (0201) |
| Mounting | Surface mount |
| Operating temperature | -55 °C to +125 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data 11227 |

Drawing reproduced from Eaton Technical Data 11227: outline with rated mm dimensions, pad layout and marking. Tolerances are stated on the drawing.
This is a surface-mount multilayer inductor: printed coil, sintered body, silver terminations. The value is quoted at a defined test frequency because at these inductances the measurement conditions matter as much as the part.
The row reads 0.6 nH ±0.3nH with a minimum Q of 14 at 500 MHz. Q is the ratio of reactance to resistance at that frequency, so a Q of 14 means the part’s loss is about 7.14 % of its reactance in that band.
Self-resonance is quoted as 10000 MHz minimum. Below it the part is inductive; above it the inter-layer capacitance takes over. The margin between the operating band and 10000 MHz is the design headroom.
Within the MCL2V0603 family this is value 1 of 62, in a range that runs from 0.001 to 0.12 nH.
The multilayer chip family covers nanohenry to a few microhenry values in 0402 through 1812 bodies. It is the range where the inductance is too small for a wound part to be practical and where the self-resonant frequency sets the usable band.
Why is the inductance quoted at a test frequency?
At nanohenry values the parasitic capacitance and the measurement fixture both matter. The value is only meaningful at the frequency stated, and the Q column tells you how much of the reactance is loss at that point.
What happens above the self-resonant frequency?
The part becomes capacitive. Any filter or matching design has to keep the operating band below SRF, with margin for the tolerance of the value.
What happens above the self-resonant frequency?
The part becomes capacitive. Any filter or matching design has to keep the operating band below SRF, with margin for the tolerance of the value.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd