
| Parameter | Value |
|---|---|
| Orderable part number | MCLA2012V1-R680-R |
| Inductance | 0.68 nH ±10 |
| Q minimum | 25 |
| DCR maximum @ +25 °C | 650 mOhm |
| Rated current maximum | 150 mA |
| SRF minimum | 105 MHz |
| Test frequency | 25 MHz |
| Test voltage | 50 mV |
| Package | 2.0 x 1.25 mm |
| Size code | 2012 (0805) |
| Mounting | Surface mount |
| Operating temperature | -40 °C to +125 °C |
| Qualification | AEC-Q200 |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data 10977 |
Outline drawing and pad layout are on page 2 of Eaton Technical Data 10977; the package column above gives the body size in millimetres.
The inductance here is a few nanohenry, which puts the part in RF and high-speed digital territory: matching networks, filter sections, bias chokes on amplifier supplies, and the small isolation inductors that keep clock harmonics out of connectors. The multilayer body keeps the parasitics predictable, and the Q column tells you how much loss the part adds at the test frequency.
The row reads 0.68 nH ±10 with a minimum Q of 25 at 25 MHz. Q is the ratio of reactance to resistance at that frequency, so a Q of 25 means the part’s loss is about 4 % of its reactance in that band.
Self-resonance is quoted as 105 MHz minimum. Below it the part is inductive; above it the inter-layer capacitance takes over. The margin between the operating band and 105 MHz is the design headroom.
Within the MCLA2012V1 family this is value 15 of 30, in a range that runs from 0.047 to 12 nH.
The multilayer chip family covers nanohenry to a few microhenry values in 0402 through 1812 bodies. It is the range where the inductance is too small for a wound part to be practical and where the self-resonant frequency sets the usable band.
How much does the value drift with temperature?
The data sheet gives the tolerance band; the drift inside that band is small for this construction because there is no mechanical winding to move.
What happens above the self-resonant frequency?
The part becomes capacitive. Any filter or matching design has to keep the operating band below SRF, with margin for the tolerance of the value.
Can I replace a wire-wound chip with this part?
Only if the Q and the current rating suit the circuit. Multilayer parts have lower Q and lower current capability than wire-wound parts of the same size.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd