
| Parameter | Value |
|---|---|
| Orderable part number | MCQ1V1608-3R9-R |
| Inductance | 3.9 uH ±10 |
| Q minimum | 25 |
| DCR maximum @ +25 °C | 1300 mOhm |
| Rated current maximum | 15 mA |
| SRF minimum | 35 MHz |
| Test frequency | 10 MHz |
| Test voltage | 50 mV |
| Package | 1.6 x 0.8 mm |
| Size code | 1608 (0603) |
| Mounting | Surface mount |
| Operating temperature | -40 °C to +85 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data 11101 |

Drawing reproduced from Eaton Technical Data 11101: outline with rated mm dimensions, pad layout and marking. Tolerances are stated on the drawing.
Where a circuit needs a small, stable inductance in a package measured in millimetres, the multilayer chip is the default. Its self-resonant frequency is the practical ceiling – above it the part behaves like a capacitor, so the SRF column is the first thing to check against the operating band.
The row reads 3.9 uH ±10 with a minimum Q of 25 at 10 MHz. Q is the ratio of reactance to resistance at that frequency, so a Q of 25 means the part’s loss is about 4 % of its reactance in that band.
Self-resonance is quoted as 35 MHz minimum. Below it the part is inductive; above it the inter-layer capacitance takes over. The margin between the operating band and 35 MHz is the design headroom.
Within the MCQ1V1608 family this is value 24 of 24, in a range that runs from 0.047 to 3.9 nH.
The multilayer chip family covers nanohenry to a few microhenry values in 0402 through 1812 bodies. It is the range where the inductance is too small for a wound part to be practical and where the self-resonant frequency sets the usable band.
How much does the value drift with temperature?
The data sheet gives the tolerance band; the drift inside that band is small for this construction because there is no mechanical winding to move.
Why is the inductance quoted at a test frequency?
At nanohenry values the parasitic capacitance and the measurement fixture both matter. The value is only meaningful at the frequency stated, and the Q column tells you how much of the reactance is loss at that point.
How much does the value drift with temperature?
The data sheet gives the tolerance band; the drift inside that band is small for this construction because there is no mechanical winding to move.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd