
| Parameter | Value |
|---|---|
| Orderable part number | MTA3V3822H-3R3-R |
| Inductance | 3.3 uH |
| FLL minimum (at Isat) | 1.85 uH |
| DCR typical @ +20 °C | 0.31 mOhm |
| DCR maximum @ +20 °C | 0.36 mOhm |
| Irms (DC, 40 °C rise) | 114 A |
| Isat | 170 A |
| SRF typical | 16.6 MHz |
| K-factor | 10.8 |
| Mounting | Through-hole |
| Operating temperature | -55 °C to +155 °C |
| Qualification | AEC-Q200 |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data ELX1530 |

Drawing reproduced from Eaton Technical Data ELX1530: outline with
rated mm dimensions, pad layout and marking.
A molded through-hole power inductor: the winding is pressed into a magnetic body with leads formed for plated holes. The molding contains the field and the leads carry heat into the board, which is how this family reaches high current in a small volume.
At 114 A the winding dissipates about 4.03 W in copper using the typical DCR of 0.31 mOhm. That is the DC floor of the loss budget – ripple and core loss come on top.
The core stores about 47685 uJ at the saturation point, which is the energy available to bridge a load step.
Self-resonance is 16.6 MHz typical. Keep the operating band, and the harmonics that carry energy, below it.
The K-factor of 10.8 converts inductance and ripple into flux swing; read the core-loss curve at that amplitude.
Within the MTA3V3822H family this is value 3 of 3, in a range from 0.82 uH to 3.3 uH.
The MTA family is the molded through-hole high-current range: AEC-Q200 qualified, with two Irms and two Isat columns for thermal and transient checks.
Why through-hole for this current level?
The leads carry heat into the board copper and the body is not limited by reflow standoff, which is how the part reaches its current rating.
Why two Irms and two Isat columns?
The datasheet gives both a typical and a maximum condition for each limit, so the thermal and the transient margins can be checked against the worst case.
Why two Irms and two Isat columns?
The datasheet gives both a typical and a maximum condition for each limit, so the thermal and the transient margins can be checked against the worst case.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd