
| Parameter | Value |
|---|---|
| Orderable part number | POEB2FB1V24W2X12 |
| Output power | 24 W |
| OCL (primary inductance) | 11.5 uH |
| SCL (saturated inductance) | 0.5 uH |
| Isat | 3 A |
| Turns ratio pri : sec : aux | 1:1:0.9:0.9 |
| Output configuration | (2) x 12.0 V |
| DCR primary | 28 mOhm |
| DCR secondary 1 | 23 mOhm |
| DCR secondary 2 | 130 mOhm |
| DCR auxiliary | 130 mOhm |
| Schematic variant | Winding arrangement 1 |
| Package | 29.3 x 21.8 x 12 mm |
| Mounting | Surface mount |
| Operating temperature | -40 C to +125 C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data ELX1269 |
Outline drawing, winding arrangement and recommended pad layout are on
page 2 of Eaton Technical Data ELX1269; the package line above gives the body size where
the data sheet states it.
This is a flyback transformer for Power over Ethernet powered devices: primary, secondary and an auxiliary winding for the controller supply, all on one bobbin with reinforced insulation between primary and secondary.
At the 3 A saturation point the primary stores about 51.8 uJ, which sets the maximum energy per switching cycle.
Within the POEB2FB1V24W2X12 family this is item 1 of 1 in the Eaton catalogue.
The PoE range covers 3 W to 156 W of output in EFD15 to EPC46 cores, flyback and forward topologies, with schematic variants for the common controller families.
What does the schematic number mean?
It refers to the winding arrangement drawing in the data sheet: which winding is primary, how many secondaries, and where the auxiliary sits. Two parts with the same power level and different schematic numbers are not interchangeable.
Is the isolation reinforced?
The transformer provides the isolation barrier for the PD; the data sheet states the test voltage. Whether that satisfies reinforced or basic isolation is a system-level question that also involves the board spacing.
Why is SCL quoted as well as OCL?
OCL is the open-circuit inductance and SCL is the saturated value. The controller needs OCL to set the current ramp and SCL to know where the core runs out, and the gap between them is the usable current range.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd