
| Parameter | Value |
|---|---|
| Orderable part number | SDCL1V2010-R68N-R |
| Inductance | 0.68 uH ±30% |
| FLL minimum (at Isat) | 0.3 uH |
| DCR typical @ +20 °C | 74 mOhm |
| DCR maximum @ +20 °C | 82 mOhm |
| Irms (DC, 40 °C rise) | 1.9 A |
| Isat | 2 A |
| Mounting | Surface mount |
| Operating temperature | -40 °C to +125 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data ELX1029 |

Drawing reproduced from Eaton Technical Data ELX1029: outline with
rated mm dimensions, pad layout and marking.
A semi-shielded power inductor: the winding is covered by a magnetic resin rather than a full metal shield. That damps the fringing field substantially without the cost and mass of a closed shield, and it lets the part be built in a low profile.
At 1.9 A the winding dissipates about 0.267 W in copper using the typical DCR of 74 mOhm. That is the DC floor of the loss budget – ripple and core loss come on top.
The core stores about 1.36 uJ at the saturation point, which is the energy available to bridge a load step.
Within the SDCL1V2010 family this is value 2 of 10, in a range from 0.47 uH to 15 uH.
The SDC family is the semi-shielded range: low-profile SMD inductors from about 2 mm to 6 mm, aimed at compact DC-DC converters where a full shield is not needed.
Why quote both Irms and Isat?
Because they describe different failure modes: overheating and saturation. A design has to satisfy both.
Can it be used in an automotive module?
The commercial SDC parts are not AEC-Q200 qualified. Use the SDCA version where qualification is required.
Is the inductance stable with temperature?
The tolerance is quoted over the operating range; the drift inside that band is small for a wound ferrite part.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd