
| Parameter | Value |
|---|---|
| Orderable part number | WCL3225-3R9-R |
| OCL | 3.9 uH ±5% |
| Q minimum @ test frequency | 12 @ 7.96 MHz |
| SRF minimum | 75 MHz |
| DCR maximum @ +25 °C | 1200 mOhm |
| Rated current (20 °C rise) | 360 mA |
| OCL test frequency | 7.96 MHz |
| OCL test voltage | 500 mV |
| Package | 3.5 x 2.9 mm, 2.25 mm high |
| Mounting | Surface mount |
| Operating temperature | -40 °C to +85 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data 10931 |

Drawing reproduced from Eaton Technical Data 10931: outline views
with rated mm dimensions, pad layout and marking.
A wire wound chip inductor is a coil wound on a ceramic or ferrite core with metal end terminals, in a body the size of a resistor. Compared with a multilayer chip of the same size it gives a higher Q and a tighter tolerance, which is why it appears in filters and matching networks rather than only in supply decoupling.
At the 360 mA rating the winding drops about 432 mV and dissipates 156 mW. Both are small enough to ignore in a bias network but not in a high-Q filter.
Q of 12 at 7.96 MHz with self-resonance at 75 MHz puts the useful band comfortably below the point where the winding capacitance takes over.
Within the WCL3225 family this is value 13 of 39, in a range from 0.12 to 560 uH.
The WCL and WCLA families run from 1.0 nH in a 1.19 x 0.66 mm body to 560 uH in 3.5 x 2.9 mm, with Q quoted at a stated test frequency for every row.
What does the rated current mean here?
It is the current that produces a 20 °C self-temperature rise, not a saturation limit. On a ceramic-core part there is no saturation to speak of, so the thermal figure is the only limit.
Is the automotive version electrically different?
The construction is the same; the qualification and the temperature range are not. The WCLA parts are AEC-Q200 qualified and rated to +125 °C, the commercial WCL parts to +85 °C.
Can I place it with a standard chip shooter?
Yes, the body and terminals are dimensioned for tape and reel and standard nozzle placement. Check the terminal width against the pad geometry in the drawing.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd